EtherCAT Coupler with ID switch and M8 connection EK1101-0008
Power LEDs
E-bus
Coupler
supply
Input for
power contacts
Power contacts
Signal input EtherCAT
Signal output EtherCAT
ID switch
extended temperature range

EK1101-0008 | EtherCAT Coupler with ID switch and M8 connection

The EK1101-0008 coupler connects EtherCAT with the EtherCAT Terminals (ELxxxx). Compared with the EK1101, the EK1101-0008 has two M8 sockets, which are compatible with the EtherCAT Box modules. The coupler is connected to the network via the upper Ethernet interface. The lower M8 socket may be used to connect further EtherCAT devices in the same strand. In the EtherCAT network, the EK1100-0008 coupler can be installed anywhere in the Ethernet signal transfer section (100BASE-TX) – except directly at the switch. If Ethernet cables with adequate performance are used, e.g. ZK1090-3131-1xxx, line lengths of 100 m are possible via M8.

The EK1101-0008 has three hexadecimal ID switches for assigning an ID to a group of EtherCAT components. This group can then be located at any position within the EtherCAT network. Variable topologies are therefore easily implementable.

Technical data EK1101-0008
Task within EtherCAT system coupling of EtherCAT Terminals (ELxxxx) to 100BASE-TX EtherCAT networks, with identity verification
Data transfer medium Ethernet/EtherCAT cable (min. Cat. 5), shielded
Distance between stations max. 100 m (100BASE-TX)
Number of EtherCAT Terminals up to 65,534
Type/number of peripheral signals max. 4.2 GB addressable I/O points
Number of configurable IDs 4096
Protocol EtherCAT
Delay approx. 1 µs
Data transfer rates 100 Mbit/s
Bus interface 2 x M8, shielded, screw type
Power supply 24 V DC (-15 %/+20 %)
Current consumption from US 70 mA + (∑ E-bus current/4)
Current consumption from UP load
Current supply E-bus 2000 mA
Current consumption E-bus
Power contacts max. 24 V DC/max. 10 A
Electrical isolation 500 V (power contact/supply voltage/Ethernet)
Weight approx. 110 g
Operating/storage temperature -25…+60 °C/-40…+85 °C
Relative humidity 95 %, no condensation
Vibration/shock resistance conforms to EN 60068-2-6/EN 60068-2-27
EMC immunity/emission conforms to EN 61000-6-2/EN 61000-6-4
Protect. class/installation pos. IP 20/variable
Approvals/markings CE
Accessories  
Cordsets cordsets and connectors
System  
EtherCAT For further EtherCAT products please see the system overview